Setting a Single Walk-In Shower Panel Plus Custom Glass Table Tops on Friday

Setting a Single Walk-In Panel

On Friday afternoon, we wrapped up our week with a clean walk-in shower project over off Shell Road. The homeowner wanted an open-concept wet area, which called for a single fixed heavy glass panel to keep the walk-in entry wide while preventing water from splashing toward the vanity.

When you are fitting frameless shower doors in Georgetown TX, a simple single-panel layout can actually be one of the trickiest to set up. Without a top header bar or a return panel to lock things together, all the structural stability relies entirely on two wall clamps and a couple of bottom support blocks anchored directly into the curb. We brought out a 3/8-inch thick tempered glass panel, pre-measured to accommodate a slight lean in the wall tile while staying completely plumb.

Aligning Tile Clamps and Curb Seals

Before drilling into the porcelain tile, we marked our clamp locations precisely on the grout lines where possible. Drilling through hard porcelain requires a wet diamond core bit and a steady hand so you do not crack the surrounding glaze. Once the mounting holes were prepped and set with solid anchors, we set rubber setting blocks on the curb and lifted the panel using heavy suction cups.

Proper shower glass installation comes down to patience during this alignment stage. Old tile walls are rarely 100 percent plumb, so we adjusted our brass wall clamps to absorb the slight run-out without placing twisting force on the glass edge. Forcing heavy glass into a misaligned clamp creates hidden stress points. Once the panel was plumb, leveled, and secured in the mechanical fasteners, we ran a crisp bead of clear mold-resistant silicone along the curb and wall seams.

Taking Measurements for Office Furniture

While the silicone was settling, the homeowner asked if we could take a look at a pair of solid walnut desks in their home study. They wanted to guard the fine wood finishes against scuffs, coffee rings, and daily wear without hiding the natural grain under heavy pads.

We pulled precise field measurements for custom glass table tops featuring 1/4-inch clear glass, smooth pencil-polished edges, and matched radius corners. Providing cut-to-size protective glass for furniture is a regular part of our routine as a full-service glass company near Georgetown Texas. By the time we loaded our suction lifts back into the truck on Friday evening, the shower screen was solid and the surface glass order was ready to send off for edging.

Reach out to our team if you would like to schedule a measurement for your next glass project.